Manual Transmission and Differential - 6MT
Oil SealREPLACEMENT
1) Clean the transmission exterior.
2) Drain transmission gear oil completely.
3) Remove the rear exhaust pipe and muffler.
4) Remove the heat shield cover.
5) Remove the propeller shaft.
6) Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
7) Using the ST, install the oil seal.
NOTE:
When grease is not applied to the oil seal lips, apply the transmission gear oil to the oil seal lips.
ST 498057300 INSTALLER
8) Install the propeller shaft.
9) Install the heat shield cover.
10) Install the rear exhaust pipe and muffler.
11) Pour in transmission gear oil and check the oil level.