Removal and Replacement
Control Valve BodyREMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift up the vehicle.
4) Clean the transmission exterior.
5) Remove the drain plug (ATF) to drain ATF.
CAUTION:
Directly after the vehicle has been running or the engine has been long idle running, the ATF is hot. Be careful not to burn yourself.
6) Tighten the drain plug (ATF).
NOTE:
Use a new gasket.
Tightening torque:
25 Nm (2.5 kgf-m, 18.4 ft-lb)
7) Remove the oil pan.
CAUTION:
Be careful not to allow foreign matter such as dust or dirt to enter the oil pan.
8) Remove the magnet.
9) Clean the magnet.
10) Completely remove the remaining liquid gasket on the transmission case and oil pan.
11) Disconnect the control valve connector.
12) Remove the oil cooler pipe.
13) Remove the control valve body.
NOTE:
The control valve body is replaced as an assembly only, because it is a non-disassembly part.
INSTALLATION
1) Check the control valve body for dust and other foreign matter.
2) Temporarily attach the control valve body to the transmission.
3) Install the oil cooler pipe.
Tightening torque:
8 Nm (0.8 kgf-m, 5.9 ft-lb)
4) Tighten the bolts equally.
Tightening torque:
8 Nm (0.8 kgf-m, 5.9 ft-lb)
5) Connect the control valve connector.
6) Attach the magnet at the specified position of the oil pan.
7) Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020) or equivalent
8) Fill the three holes aside from the bolt holes in the transmission case, with liquid gasket.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020) or equivalent
9) Install the oil pan by equally tightening the bolts.
Tightening torque:
5 Nm (0.5 kgf-m, 3.7 ft-lb)
10) Lower the vehicle.
11) Connect the ground cable to battery.
12) Fill ATF from the oil charge pipe. A/T Fluid Inspection
13) Bleed the air of control valve.
14) Check the ATF level. A/T Fluid Inspection
15) Perform the diagnosis again. Programming and Relearning
INSPECTION
Check parts for holes, damages or adhesion of dust and other foreign particles