Transmission Gear Oil Replacement

Transmission Gear Oil

REPLACEMENT
1) Pull out the oil level gauge.
2) Lift up the vehicle.
3) Using the TORX� bit T70, remove the drain plug, and drain the transmission gear oil completely.

CAUTION:
^ Immediately after the engine has been running, the transmission gear oil will be hot. Be careful not to burn yourself.
^ Be careful not to spill the transmission gear oil on the exhaust pipe, to prevent emission of smoke or causing a fire. If gear oil is spilled, wipe it off completely.

4) Using the TORX� bit T70, tighten the transmission gear oil drain plug.

NOTE:
^ T1ghten the drain plug of the transmission gear oil after draining the transmission gear oil.
^ Use a new gasket.





5) Lower the vehicle.
6) Pour gear oil through the oil level gauge hole.
Recommended gear oil:
GL-5 (75W-90) or equivalent
Gear oil capacity:
3.5 V (3.7 US qt, 3.1 Imp qt)
7) Measure the transmission gear oil amount, and check that it is within the specification.

CAUTION:
When inserting the oil level gauge into transmission, align the protrusion on the top part of the oil level gauge with the notch in the oil level gauge hole.