Map Light: Testing and Inspection
Spot Map LightINSPECTION
1. SPOT MAP LIGHT BULB
1. Visually check the bulb for blow out.
2. Check the bulb specification.
3. If NG, replace the bulb with a new part.
2. SPOT MAP LIGHT SWITCH
Measure the resistance between spot map light terminals.
Replace the overhead console assembly if faulty.
3. SPOT MAP LIGHT SLIDE SWITCH
1. Turn the spot map light switch to OFF.
2. Measure the resistance between spot map light slide switch terminals.
Replace the overhead console assembly if faulty.
4. OVERHEAD CONSOLE ILLUMINATION LIGHT BULB
1. Install the overhead console assembly to test if it illuminates normally.
2. If it does not light properly, replace the overhead console assembly.
NOTE: Since LEDs (Light Emitting Diode) are used for the overhead console illumination lamp bulb, replace the overhead console assembly if an LED burns out.