Radiator Main Fan

Radiator Main Fan and Fan Motor





REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.





3) Lift up the vehicle.
4) Remove the under cover.
5) Disconnect the connector (A) of the main fan motor assembly.





6) Remove the heat shield cover. (AT model)





7) Remove the ATF hose from the clip of the radiator main fan shroud. (AT model)
8) Lower the vehicle.
9) Disconnect the over flow hose.
10) Remove the reservoir tank.
11) Drain approximately 2 l of coolant.
12) Disconnect the radiator inlet hose from the radiator.





13) Remove the bolts which hold the radiator main fan shroud to the radiator.





14) Remove the radiator main fan and fan motor from vehicle.

INSTALLATION

CAUTION:
Check if the radiator hose and the over flow hose are properly connected.

Install in the reverse order of removal.

NOTE:
If the installation of the radiator main fan and fan motor is difficult, attempt installation after loosening the bolts which hold the radiator sub fan shroud to the radiator.








DISASSEMBLY
1) Remove the clip which holds the main fan motor assembly connector onto the radiator main fan shroud.
2) Remove the main fan motor assembly from the radiator main fan shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.





INSPECTION
Check that the radiator main fan, radiator main fan shroud and main fan motor assembly do not have deformation, cracks or damage.