Reading Diagnostic Trouble Codes
Subaru Select MonitorOPERATION
1) Prepare the Subaru Select Monitor kit.
2) Prepare PC with Subaru Select Monitor installed.
3) Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Selector Monitor) using a USB cable.
NOTE:
Port exclusively for Subaru Select Monitor refers to the USB port used when installing Subaru Select Monitor.
4) Connect the diagnosis cable to SDI.
5) Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION:
Do not connect the scan tools other than the Subaru Select Monitor.
6) Start the PC.
7) Turn the ignition switch to ON.
8) Run the "PC application for Subaru Select Monitor".
Read Current Data
OPERATION
1) Using the Subaru Select Monitor, on the [Main Menu] display, select (Each System Check).
2) On [System Selection Menu] display, select (Transmission).
3) After transmission type information pops up, select [OK].
4) On [Transmission Diagnosis] display, select (Current Data Display & Save).
5) On [Current Data Display & Save] display, select (Normal sampling).
6) Move the screen up or down with the scroll keys, and display the data you wish to view.
^ The support data list is as follows.
NOTE:
For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
Read Diagnostic Trouble Code (DTC)
OPERATION
1) Using the Subaru Select Monitor, select (Each System Check in the [Main Menu].
2) On the [Each System Check Menu] screen, select (Transmission Control System).
3) After transmission type information is displayed, select [OK].
4) On the [Transmission Diagnosis], select (Diagnostic Code(s) Display).
5) On the [DTC Display] screen, select (Temporary Diagnostic Code(s) or (Memorized Diagnostic Code(s)).
NOTE:
^ For details concerning the work procedure, refer to the "PC application help for Subaru Select Monitor".
^ For details concerning DTC, refer to List of Diagnostic Trouble Code (DTC).