Removal and Replacement
Select LeverREMOVAL
1) Set the vehicle on a lift.
2) Shift the select lever to "N" range.
3) Disconnect the ground cable from battery.
4) Lift up the vehicle.
5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover.
7) Disconnect the cable from the arm COMPL.
8) Raise the claw of clamp to remove the select cable.
9) Lower the vehicle.
10) Remove the grip.
11) Remove the parking brake lever boot.
12) Remove the console box.
13) Remove the console front panel.
14) Remove the indicator assembly.
15) Remove the harness clips from the bracket.
16) Remove the blind.
17) Disconnect the connectors, remove the four bolts and take out the select lever COMPL from vehicle body.
INSTALLATION
1) Set the select lever to vehicle body.
2) Tighten the four bolts to install the select lever to vehicle body, and then connect the connector.
1) Temporarily tighten the bolt A.
2) Tighten the bolt B.
3) Tighten the bolt A.
4) Tighten the bolts C and D.
3) Install the harness clips to the bracket.
4) Shift the select lever to "N" range.
5) Install the blind.
CAUTION:
The blind should be installed so that it is securely caught by tabs of the plate guide COMPL.
6) Install the indicator assembly.
7) Install the console front panel.
8) Install the console box.
9) Install the parking brake lever boot.
10) Install the grip.
11) Lift up the vehicle.
12) Shift the range select lever to "N" range.
13) Secure the select cable to the bracket.
14) Adjust the select cable position.
15) After the completion of adjustment, confirm that the select lever operates properly at all range positions.
16) Install the heat shield cover.
17) Install the rear exhaust pipe and muffler.
18) Lower the vehicle.
19) Connect the ground cable to battery.
20) Inspect the following items. When a problem is found in the inspection, adjust the select cable and inhibitor switch.
1) Engine starts when the select lever is in "P" and "N" range, but not in other ranges.
2) Back-up light illuminates when the select lever is in the "R" range, but not in other ranges.
3) Select lever and indicator positions are matched.