Front Crossmember Support Plate
Front Crossmember Support PlateREMOVAL
1) Lift up the vehicle
2) Remove the front under cover.
3) Remove the bolt and remove front crossmember support plate.
^ Large type
^ Small type
INSTALLATION
Install in the reverse order of removal.
NOTE:
Tighten the small type crossmember support plate together with stabilizer bracket.
After installing the stabilizer bracket to the crossmember, tighten the crossmember support plate together.
Tightening torque:
Crossmember support plate:
60 N.m (6.1 kgf-m, 44.3 ft-lb)
Crossmember support plate (Tightened together with the stabilizer bracket):
25 N.m (2.5 kgf-m, 18.4 ft-lb)
Jack-up plate:
60 N.m (6.1 kgf-m, 44.3 ft-lb)