Front Wiper Motor and Link
Front Wiper Motor and LinkREMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the cowl panel.
3. Disconnect the connector of motor.
4. Remove the bolt, and then remove the wiper link.
5. Remove the bolts and nuts and remove the motor.
INSTALLATION
1. Connect the ground cable to battery.
2. To confirm that the motor is at the auto stop position, connect the harness to the motor and turn the wiper switch to ON/OFF once.
3. Disconnect the ground cable from battery.
4. Tighten the nut where rod (A) and link plate (B) is aligned in a straight line.
5. Install in the reverse order of removal.
Tightening torque: N.m (kgf.m, ft.lb)
T1: 6.0 (0.61, 4.4)
T2: 20 (2.04, 14.8)