Removal and Replacement
REMOVAL1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Lift up the vehicle.
4. Clean the transmission exterior.
5. Remove the drain plug (ATF) to drain the ATF.
CAUTION: After running the engine or after idling for a long time, the ATF is hot. Be careful not to burn yourself.
6. Perform replacement with a new gasket, and tighten the drain plug (ATF).
Tightening torque: 25 N-m (2.5 kgf-m, 18.4 ft-lb)
7. Remove the oil pan.
CAUTION: Be careful not to allow foreign matter such as dust or dirt to enter the oil pan.
8. Remove the magnet.
9. Clean the magnet.
10. Completely remove the remaining liquid gasket on the transmission case and oil pan.
11. Disconnect the control valve connector.
12. Remove the oil cooler pipe.
13. Remove the control valve body.
NOTE: The control valve body is replaced as an assembly only, because it is a non-disassembly part.
INSTALLATION
1. Check the control valve body for dust and other foreign matter.
2. Temporarily attach the control valve body to the transmission.
3. Install the oil cooler pipe.
Tightening torque: 8 N-m (0.8 kgf-m, 5.9 ft-lb)
4. Tighten the bolts equally.
Tightening torque: 8 N-m (0.8 kgf-m, 5.9 ft-lb)
5. Connect the control valve connector.
6. Attach the magnet at the specified position of the oil pan.
7. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket. THREE BOND 1217B (Part No. K0877YA020) or equivalent
8. Fill the 3 holes aside from the bolt holes in the transmission case, with liquid gasket.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020.or equivalent
9. Install the oil pan by equally tightening the bolts.
Tightening torque: 5 N-m (0.5 kgf-m, 3.7 ft-lb)
10. Fill ATF from the oil charge pipe.
11. Bleed the air of control valve body.
12. Check the ATF level.
13. Execute the learning control promotion.
INSPECTION
Check parts for holes, damages or adhesion of dust and other foreign particles.