Front Wiper Motor and Link

Front Wiper Motor and Link

REMOVAL

1. Disconnect the ground cable from the battery.
2. Remove the cowl panel.
3. Disconnect the connector of motor.
4. Remove the bolt, and remove the wiper link.

5. Remove the TORX(R) bolt and nuts, and remove the wiper motor assembly.

INSTALLATION

1. Connect the battery ground cable to the battery.
2. To confirm that the motor is at the auto stop position, connect the harness to the motor, and turn the wiper switch ON/OFF.
3. Disconnect the ground cable from the battery.
4. Install the wiper motor assembly.

Front Wiper:

5. Tighten the nut of the link plate and motor assembly.

CAUTION: Tighten the nut where rod (A) and link plate (B) is aligned in a straight line.

6. Install in the reverse order of removal.

FRONT WIPER