Seat Belt: Service and Repair

Front Seat Belt

REMOVAL

1. OUTER SEAT BELT ASSEMBLY

CAUTION:
- Do not drop or subject the pretensioner to any impact.
- Since the pretensioner and bracket are integrated as a unit, do not disassemble them.

1. Before working, turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more.
2. Fold the backrest all the way forward, and then move the front seat all the way forward.
3. Remove the center pillar lower trim.
4. Remove the anchor cover (A).
5. Loosen the shoulder anchor bolt (B), and then detach the shoulder anchor from center pillar.






6. Disconnect the belt tension sensor connector on the passenger's seat.
7. Turn over the floor mat to disconnect the belt tension sensor connector.
8. Loosen the three bolts to remove the front outer belt.






9. Remove the center pillar upper trim.
10. Remove the two bolts to remove the adjustable anchor assembly.






2. INNER SEAT BELT ASSEMBLY
1. Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more.
2. Remove the console box.
3. Disconnect the seat belt warning light connector under the seat.
4. Remove the harness clips from slide rail.
5. Remove the bolt and remove the inner seat belt assembly.






INSTALLATION

CAUTION:
- The parts of driver's seat and those of passenger's seat are not the same. Before installation, make sure that the correct part is used.
- Be careful not to twist the seat belts during installation.

Install in the reverse order of removal.

FRONT SEAT BELT

Tightening torque: N.m (kgf.m, ft.lb)
T1: 7.5 (0.76, 5.5)
T2: 30 (3.1, 22)
T3: 38 (3.9, 29)
T4: 53 (5.4, 39)