Rear Wiper Motor

REMOVAL

1. Disconnect the ground cable from the battery.
2. Remove the rear wiper arm.
3. Remove the rear gate lower trim.
4. Disconnect the harness connector of wiper motor assembly.
5. Remove the bolt, and then remove the wiper motor assembly.






INSTALLATION
1. Install in the reverse order of removal.
2. Be sure that the pivot cap with the round mark facing up, as shown in the figure.






Tightening torque:N.m (kgf-m, ft-lb)
T1: 6.0 (0.61, 4.4)
T2: 8.0 (0.82, 5.9)