Shift Interlock Solenoid: Service and Repair
AT Shift Lock Solenoid and "P" Range SwitchREMOVAL
1) Remove the grip.
2) Remove the hand brake boot cover.
3) Remove the console front panel.
4) Remove the console cover and console box.
5) Remove the indicator assembly.
6) With the shift lock release button held down, move the select lever to the "N" range.
7) Remove the spacer bolt and remove the plate guide COMPL.
8) Using a flat-tip screwdriver with a thin tip, remove the connector from the plate COMPL.
9) With detent spring lifted up, push the select lever backward and remove the shift lock solenoid unit.
10) Raise the claw of connector.
11) Disconnect the terminals of "P" range switch and shift lock solenoid unit from the connector, using a flat-tip screwdriver with a thin tip.
INSTALLATION
Install in the reverse order of removal.
NOTE:
^ Refer to "COMPONENT" for each tightening torque.
^ Set the select lever to "D" range (normal mode position) when installing the guide plate and be careful of the following.
^ Insert protrusion (B) of the guide plate into the hole on the shift lock solenoid unit (A).
^ Insert link (D) of the shift lock release into link (C) of the shift lock solenoid unit.
^ Connect the switch and solenoid terminals to the connector.
INSPECTION
Step 1-Step 4:
