Rear Door Window Glass: Service and Repair

REAR DOOR GLASS

Rear Door Glass:

REMOVAL

1. Remove the rear door trim.
2. Remove the sealing cover.
3. Operate the power window switch to move the glass, and remove the two bolts.






4. Remove the glass from the carrier plate, and while holding the glass, lower the carrier plate alone to the lowest position.

CAUTION:
- Without the carrier plate lowered to the bottom most position, do not lower the glass by itself to the lowest position within the door panel.
- The glass may come off of the sash, and become damaged.

5. Lower the glass slowly to the bottom most position in the door panel.
6. Remove the bolts and nuts, and then remove the sash. (Detach starting from the upper holding points.)






7. Remove the glass run rubber.
8. Remove the door glass while tilting the glass.

CAUTION: Avoid impact and damage to the glass.

INSTALLATION

Install in the reverse order of removal.

CAUTION: Make sure that the glass run rubber is placed securely onto the door flame and sash.

Tightening torque:
Refer to "COMPONENT" of "General Description".