Overhaul

Select Lever

DISASSEMBLY
1) Remove the packing.
2) Remove the grip.
3) Remove the indicator light, and then remove the indicator cover.

NOTE: Be careful not to damage the indicator light during removal.





4) Remove the blind.
5) Remove the cover.





6) Remove the clips and then remove the guide plate.





7) Remove the clamp and remove the shift lock solenoid.





8) Remove the bolts which secure the lock plate B.





9) Remove the lock plates A, B, and C and the bushing.





10) Remove the cushion plate.





11) Remove the "P" range switch.





12) Remove the grommet and then extract the spring pin.





13) Remove the select lever arm and then remove the select lever COMPL from the plate.





14) Remove the detent spring and remove the de-tent arm.





15) Remove the select lever COMPL bushing from bracket.





16) Remove the bracket from select lever COMPL.





17) Remove the bushing from the bracket.





ASSEMBLY
1) Clean all the parts before assembly.
2) Apply NIGTIGHT LYW NO. 2 grease or the equivalent to each part.

CAUTION: Apply grease [SUNCALL GLO-244] to the axle of lock plate.

3) Assemble in the reverse order of disassembly.
4) After completion of fitting, transfer the select lever to the "1" range from "P" range, then check whether the select indicator and select lever match, and whether the pointer and position mark match and check the operating force.

INSPECTION
1) Inspect the removed parts by comparing with new parts for deformation, damage and wear. Repair or replace if defective.
2) Confirm the select lever COMPL operating condition before assembling. Normal if it operates smoothly.