Removal and Replacement

Select Cable

REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Prior to removal, set the lever to "N" range.
4) Lift up the vehicle.
5) Remove the front and center exhaust pipes.
6) Remove the snap pin and washer from the range select lever.





7) Remove the plate assembly from the transmission case.





8) Disconnect the select cable from range select lever and then remove the cable bracket.





9) Remove the select cable from plate assembly.

INSTALLATION
1) Install the select cable to plate assembly.
Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
2) Install the select cable to the range select lever.
3) Install the plate assembly to the transmission.
Tightening torque:
T: 25 N-m (2.5 kgf-m, 18.4 ft-lb)





4) Install the washer and snap pin to range select lever.





5) Move the select lever to the "N" range, then adjust the select cable position.
6) Install the front and center exhaust pipe.