Procedures

Select Cable

INSPECTION
Check the removed cable and replace if damaged, rusty or having problems.
1) Check the cable for smooth operation.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends and cracks.
4) Check the boot for damage, cracks and deterioration.
5) Move the select lever from "P" to "1" range. In each range, check that the contact of the detent is felt. If the detentes is not felt or the position pointer is improperly aligned, adjust the cable.

ADJUSTMENT
1) Set the vehicle on a lift.
2) Set the select lever to "N" range.
3) Lift up the vehicle.
4) Remove the rear exhaust pipe and muffler.
5) Loosen the adjusting nuts on both sides.





6) Turn the adjusting nut B until it lightly touches the connector.





7) Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque: 7.5 N-m (0.76 kgf-m, 5.5 ft-lb)





8) After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
9) Install in the reverse order of removal.