Transmission Mount: Service and Repair
Transmission Mounting SystemREMOVAL
PITCHING STOPPER
1. Remove the air intake chamber.
2. Remove the pitching stopper.
TRANSMISSION REAR CROSSMEMBER AND REAR CUSHION RUBBER
1. Disconnect the ground cable from battery.
2. Jack-up the vehicle and support it with rigid racks.
3. Remove the front, center, rear, exhaust pipes and muffler.
4. Remove the heat shield cover.
5. Set the transmission jack under the transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
6. Remove the transmission rear crossmember.
7. Remove the rear cushion rubber.
INSTALLATION
PITCHING STOPPER
1. Install the pitching stopper.
Tightening torque:
T1: 50 Nm (5.1 kgf-cm, 37 ft. lbs.)
T2: 58 Nm (5.9 kgf-cm, 43 ft. lbs.)
2. Install the air intake chamber.
TRANSMISSION REAR CROSSMEMBER AND REAR CUSHION RUBBER
1. Install the rear cushion rubber.
Tightening torque: 40 Nm (4.1 kgf-cm, 29.5 ft. lbs.)
2. Install the crossmember.
Tightening torque:
T1: 35 Nm (3.6 kgf-cm, 26 ft. lbs.)
T2. 75 Nm (7.6 kgf-cm 55 ft. lbs.)
3. Remove the transmission jack.
4. Install the heat shield cover.
5. Install the front, center and rear exhaust pipes and muffler.
INSPECTION
Repair or replace parts if the results of the inspection below are not satisfied.
PITCHING STOPPER
Make sure that the pitching stopper is not bent or damaged. Ensure there are no cracks, hardening, or damage on rubbers.
TRANSMISSION REAR CROSSMEMBER AND REAR CUSHION RUBBER
Make sure that the crossmember is not bent or damaged. Ensure there are no cracks, hardening, or damage on cushion rubbers.