Removal and Replacement
TurbochargerEXCEPT FOR STI MODEL
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from the battery.
3. Remove the center exhaust pipe.
4. Lower the vehicle.
5. Separate the turbocharger joint pipe from turbocharger.
6. Disconnect the engine coolant hose which is connected to coolant filler tank.
7. Loosen the clamp which secures turbocharger to intake duct.
8. Remove the bolts which secure oil inlet pipe bracket to turbocharger.
9. Disconnect the engine coolant hose from the pipe, and remove the turbocharger bracket RH.
10. Remove the oil inlet pipe from turbocharger.
(A) Oil inlet pipe
(B) Metal gasket
11. Disconnect the oil outlet hose from pipe.
12. Take out the turbocharger from engine compartment.
INSTALLATION
1. Connect the oil outlet hose to outlet pipe.
2. Install the turbocharger to intake duct.
Tightening torque: 3 N.m (0.3 kgf-m, 2.2 ft-lb)
3. Install the oil inlet pipe to turbocharger.
NOTE: Use a new gasket.
Tightening torque:
T1: 16 N.m (1.6 kgf-m, 11.6 ft-lb)
T2: 29 N.m (3.0 kgf-m, 21.7 ft-lb)
T3: 4.9 N.m (0.50 kgf-m, 3.6 ft-lb)
4. Install the turbocharger bracket RH, and connect the engine coolant hose to the pipe.
Tightening torque: 33 N.m (3.4 kgf-m, 24.6 ft-lb)
5. Install the joint pipe to turbocharger.
NOTE: Use a new gasket.
Tightening torque: 35 N.m (3.6 kgf-m, 25.8 ft-lb)
6. Connect the engine coolant hose which is connected to the coolant filler tank.
7. Lift up the vehicle.
8. Install the center exhaust pipe.
9. Connect the ground cable to the battery.