Extension Case Oil Seal
Extension Case Oil SealINSPECTION
Make sure that the ATF is not leaking from the transmission and propeller shaft joint. If there is leakage, replace the oil seal and check the propeller shaft.
REPLACEMENT
1. Clean the transmission exterior.
2. Drain the ATF completely.
NOTE: Tighten the drain plug (ATF) after draining the ATF.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
3. Remove the rear exhaust pipe and muffler.
4. Remove the heat shield cover. (If equipped)
5. Remove the propeller shaft.
6. Using the ST, remove the oil seal. ST 398527700 PULLER ASSEMBLY
7. Using the ST, install the oil seal.
ST 498057300 INSTALLER
8. Install the propeller shaft.
9. Install the heat shield cover. (If equipped)
10. Install the rear exhaust pipe and muffler.
11. Pour in ATF.
12. Bleed the air of control valve.
13. Check the level and leaks of the ATF.