Disassembly and Assembly

DISASSEMBLY




1. Remove the fuel pipe protector RH.




2. Remove the fuel pipe protector LH.







3. Remove the engine ground terminal from the intake manifold.




4. Disconnect the connector from the throttle position sensor (A), and the manifold pressure sensor (B).




5. Remove the throttle body to intake manifold.




6. Disconnect the connector from fuel injector.




7. Disconnect the connector from tumble generator valve actuator.




8. Disconnect the connector from tumble generator valve sensor.
9. Disconnect the connector from purge control solenoid valve.




10. Remove the purge control solenoid valve.




11. Disconnect the evaporation hose and purge valve from the intake manifold.




12. Remove the two bolts which hold fuel pipes on the left side of intake manifold.
13. Remove the bolt which holds fuel injector pipe onto intake manifold.







- LH side







- RH side




14. Remove the fuel injector.




15. Remove the harness bracket which holds the engine harness onto intake manifold.
16. Remove the engine harness from intake manifold.




17. Loosen the clamp which holds the front LH side fuel hose to injector pipe to remove the pipe from clamp.




18. Loosen the clamp which holds the RH side fuel hose to injector pipe to remove the pipe from clamp.




19. Remove the bolts which install fuel pipes on intake manifold.
20. Remove the fuel pipe assembly and pressure regulator from intake manifold.




21. Remove the intake duct from intake manifold.




22. Remove the tumble generator assembly from intake manifold.

ASSEMBLY

NOTE: Replace with a new gasket.




1. Install the tumble generator valve assembly onto intake manifold.




2. Install the air intake duct to the intake manifold.




3. Install the fuel pipe assembly and pressure regulator to intake manifold.
4. Install the fuel injector pipe LH.




5. Connect the left side fuel hose LH to the injector pipe, and tighten the clamp screw.
6. Install the fuel injector pipe RH.




7. Connect the fuel hose RH to the injector pipe, and tighten the clamp screw.
8. Install the engine harness onto intake manifold.




9. Install the harness bracket which holds the engine harness onto intake manifold.

10. Tighten the bolts which secure fuel injector pipe onto intake manifold.







- LH side







- RH side




11. Tighten the two bolts which install the fuel pipe on the left side of intake manifold.




12. Connect the evaporation hose to the purge valve.

NOTE: Connect the evaporation hose as shown in the figure.




13. Connect the evaporation hose and purge valve to the intake manifold.




14. Install the purge control solenoid valve.




15. Connect the hose to the purge control solenoid valve.

NOTE: Connect the evaporation hose as shown in the figure.

16. Connect the connector to the purge control solenoid valve.




17. Connect the connector to the tumble generator valve sensor.




18. Connect the connector to the tumble generator valve actuator.




19. Connect the connector to the fuel injector.




20. Install the throttle body to intake manifold.

NOTE: Replace with a new gasket.




21. Connect the connector to the throttle position sensor (A), and the manifold pressure sensor (B).







22. Install the engine ground terminal to the intake manifold.




23. Install the fuel pipe protector RH.




24. Install the fuel pipe protector LH.