Radiator Main Fan and Fan Motor

Radiator Main Fan and Fan Motor

Turbo model:

1. Set the vehicle on a lift.
2. Remove the collector cover.
3. Disconnect the ground cable from battery.





4. Remove the radiator upper brackets. (AT model)





5. Lift-up the vehicle.
6. Remove the undercover.
7. Drain the coolant about 1 ohms (1.06 US qt, 0.88 Imp qt).
8. Disconnect the connectors of radiator main fan motor connector (A) and sub fan motor connector (13).





9. Remove the radiator under cover attaching bolts. (AT model)





10. Lift the radiator lower hose and float the radiator from the radiator under cover. Remove the ATF hose from 2 places on the clip of radiator fan motor assembly. (AT model)





11. Lower the vehicle.
12. Remove the reservoir tank.





13. Remove the mounting bolts from radiator main fan motor assembly.





14. Disconnect the radiator inlet hose and the over flow hose.





15. Disconnect the power steering hose from the clip on the radiator.





16. Remove the radiator main fan motor assembly from vehicle.





INSTALLATION
1. Install the radiator main fan motor assembly to the radiator.
2. Lift-up the vehicle.
3. Lift the radiator lower hose and float the radiator from the radiator under cover. Connect the ATF hose to 2 locations on the clip of radiator main fan motor assembly. (AT model)

NOTE: Make pins on the lower side of radiator be fitted into the vehicle side.





4. Tighten the attachment bolts of the radiator under cover. (AT model)





5. Connect the radiator main fan motor connector (A) and sub fan motor connector (13).





6. Install the under cover.
7. Lower the vehicle.
8. Connect the power steering hose to the clip on the radiator.





9. Connect the radiator inlet hose and the overflow hose to radiator.





10. Install the mounting bolts to radiator main fan motor assembly.
Tightening torque: 4.9 Nm (0-5 kgf-m, 3.6 ft. lbs.)





11. Install the reservoir tank.
Tightening torque: 7.5 Nm (0. 76 kgf-m, 5.5 ft. lbs.)





12. Install the radiator upper brackets. (AT model)





13. Connect the ground cable to battery.





14. Fill engine coolant.
15. Install the collector cover.

DISASSEMBLY
1. Remove the clip which holds motor connector onto the shroud.
2. Remove the nut which holds fan to fan motor and shroud assembly.





3. Remove the bolts which hold fan motor onto shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque: 4.4 Nm (0.45 kgf-m, 3.3 ft. lbs.)





Tightening torque: 3.4 Nm (0.35 kgf-m, 2.5 ft. lbs.)