Real-Time Diagnosis

REAL-TIME DIAGNOSIS

1. Connect the Subaru Select Monitor.
2. Turn the ignition switch and cruise control main switch to ON.
3. Turn the Subaru Select Monitor switch to ON.
4. On the [[Main Menu[[ display screen, select the {2. Each System Check} and press the [YES] key.
5. On the [[System Selection Menu[[ display screen, select the {Engine Control System} and press the [YES] key.
6. Press the [YES] key after the information of engine type has been displayed.
7. On the [[Engine Diagnosis[[ screen, select the {Current Data Display/Save}, and then press the[YES] key.
8. Make sure that normal indication is displayed when controls are operated as indicated below:
- Depress and release the brake pedal. (Stop light switch and brake switch are turned to ON.)
- Turn the [[SET/COAST[[ switch to ON.
- Turn the [[RESUME/ACCEL[[ switch to ON.
- Turn the [[CANCEL[[ switch to ON. (The [[SET/ COAST[[ switch and [[RESUME/ACCEL[[ switch are turned to ON at the same time.)
- Depress or release the clutch pedal.
- Place the shift lever in any position other than neutral.

NOTE:
- For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION".
- For the DTC, refer to the List of Diagnostic Trouble Code (DTC). Cruise Control - Diagnostics