Engine Oil: Service and Repair
Engine OilREPLACEMENT
1. Open the engine oil filler cap for quick draining of engine oil.
2. Lift-up the vehicle.
3. Remove the clip.
4. Rotate the service hole cover in the arrow direction.
5. Drain engine oil by loosening the engine oil drain plug.
NOTE: Prepare the container for draining of engine oil.
6. Replace the drain plug gasket.
7. Tighten the engine oil drain plug after draining engine oil.
Tightening torque: 44 Nm (4.5 kgf-m, 32.5 ft. lbs.)
8. Install the service hole cover.
9. Using engine oil of proper quality and viscosity, fill engine oil through the oil filler duct to the upper level on level gauge. Make sure that the vehicle is parked on a level surface when checking oil level.
Recommended oil
Engine oil capacity.
10. Close the engine oil filler cap.
11. Start the engine and warm it up for a time.
12. After the engine stops, recheck the oil level. If necessary, add engine oil up to the upper level on level gauge.
