Clearing Trouble Codes - With VDC
Subaru Select MonitorOPERATION
1. READ DTC
1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to Subaru Select Monitor.
3. Insert the cartridge to Subaru Select Monitor.
4. Connect the Subaru Select Monitor to the data link connector.
1. Data link connector is located in the lower portion of the instrument panel (on the driver's side).
2. Connect the diagnosis cable to data link connector.
5. Turn the ignition switch ON (engine is OFF), and the Subaru Select Monitor switch ON.
6. On the [[Main Menu]] display screen, select the (Each System Check) and press the [YES] key.
7. On the [[System Selection Menu]] display screen, select the (Brake Control) and press the [YES] key.
8. Press the [YES] key after the VDC type is displayed.
9. On the [[Brake Control Diagnosis]] screen, select the (Diagnostic Code(s) Display), and then press the [YES] key.
NOTE:
^ For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
^ For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)". ABS
^ A maximum of three DTCs are displayed in the order of occurrence.
2. READ CURRENT DATA
1. On the [[Main Menu]] display screen, select the (Each System Check) and press the [YES] key.
2. On the [[System Selection Menu]] display screen, select the (Brake Control) and press the [YES] key.
3. Press the [YES] key after the VDC type is displayed.
4. On the [[Brake Control Diagnosis]] display screen, select the (Current Data Display/Save), and then press the [YES] key.
5. On the [[Data Display Menu]] screen, select the (Data Display) and press the [YES] key.
6. Using the scroll key, scroll the display screen up or down until the desired data is shown on the screen.
^ A list of the support data is shown in the following table.
NOTE: For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
3. CLEAR MEMORY MODE
1. On the [[Main Menu]] display screen, select the (2. Each System Check) and press the [YES] key.
2. On the [[System Selection Menu]] display screen, select the (Brake Control) and press the [YES] key.
3. Press the [YES] key after the engine type is displayed.
4. On the [[Brake Control Diagnosis]] display screen, select the (Clear Memory) and press the [YES] key.
5. When the "Done" is shown on the display screen, turn the Subaru Select Monitor and ignition switch OFF.
NOTE: For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
4. FUNCTION CHECK
5. FREEZE FRAME DATA
NOTE:
^ Data stored at the time of failure occurred is shown on display.
^ Each time a failure occurs, the latest information is stored in the freeze frame data in memory.
^ 1 freeze frame data is stored.
^ If a freeze frame data is not properly stored in memory (due to a drop in VDCCM power supply, etc.), a DTC suffixed with a question mark "T' appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
FREEZE FRAME DATA LIST
