Throttle Cable/Linkage: Service and Repair

Accelerator Control Cable

REMOVAL
1. Remove the accelerator pedal.
2. Separate the accelerator cable and accelerator pedal.

INSTALLATION
1. Install in the reverse order of removal.

NOTE
- If the cable clamp is damaged, replace it with a new one.
- Never fail to cover the outer cable end with boot.
- Be careful not to kink the accelerator cable.
- Do not apply grease to except specified part.




2. Apply grease to engine side accelerator cable end.
Grease: Silicolube G-30M (Part No. 004404002)
3. After installation, adjust the pedal.