With Subaru Select Monitor
Subaru Select MonitorOPERATION
READ DTC
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select Monitor.
3) Insert the cartridge to Subaru Select Monitor.
4) Connect the Subaru Select Monitor to data link connector.
(1) Data link connector is located in the lower portion of the instrument panel (on the driver's side).
(2) Connect the diagnosis cable to data link connector.
5) Turn the ignition switch to ON (engine OFF), and the Subaru Select Monitor switch to ON.
6) On the [[Main Menu]] display screen, select the (Each System Check) and press the [YES] key.
7) On the [[System Selection Menu]] display screen, select the (Brake Control) and press the [YES] key.
8) Press the [YES] key after the information of engine type is displayed.
9) On the [[brake Control Diagnosis]] display screen, select the (Diagnostic Code(s) Display), and then press the [YES] key.
NOTE:
^ For details concerning operation procedure, refer to "SUBARU SELECT MONITOR OPERATION MANUAL".
^ For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)".
^ Maximum 3 DTCs displayed in chronological order.
^ If the vehicle in trouble, "Current" is displayed.
READ CURRENT DATA
1) On the [[Main Menu]] display screen, select the (Each System Check) and press the [YES] key.
2) On the [[System Selection Menu]] display screen, select the (Brake Control) and press the [YES] key.
3) Press the [YES] key after the VDC type is displayed.
4) On the [[Brake Control Diagnosis]] screen, select the (Current Data Display/Save), and then press the [YES] key.
5) On the [[Data Display Menu]] screen, select the (Data Display) and press the [YES] key.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
^ Following table are shown the list of support data.
NOTE: For details concerning operation procedure, refer to "SUBARU SELECT MONITOR OPERATION MANUAL".
CLEAR MEMORY MODE
1) On the [[Main Menu]] display screen, select the (2. Each System Check) and press the [YES] key.
2) On the [[System Selection Menu]] display screen, select the (Brake Control) and press the [YES] key.
3) Press the [YES] key after the engine type is displayed.
4) On the [[Brake Control Diagnosis]] display screen, select the (Clear Memory) and press the [YES] key.
5) When the "Done" are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE: For details concerning operation procedure, refer to "SUBARU SELECT MONITOR OPERATION MANUAL".
FUNCTION CHECK
FREEZE FRAME DATA
NOTE:
^ Data stored at the time of trouble occurrence is shown on display.
^ Each time trouble occurs, the latest information is stored in the freeze frame data in memory.
^ Freeze Frame Data recorded one.
^ If a freeze frame data is not properly stored in memory (Due to a drop in VDCCM power supply, etc.), the DTC which is suffixed with a question mark "?" appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
FREEZE FRAME DATA LIST