Cruise Cancel Conditions Diagnosis

CRUISE CANCEL CONDITIONS DIAGNOSIS




1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to Subaru Select Monitor.




3. Insert the cartridge into Subaru Select Monitor.
4. Connect the Subaru Select Monitor to data link connector.




1. Data link connector is located in the lower portion of the instrument panel (on the driver's side).
2. Connect the diagnosis cable to data link connector.

5. Start the engine and turn the cruise control main switch to ON.




6. Turn the Subaru Select Monitor switch to ON.
7. On the Main Menu display screen, select the (All System Diagnosis) and press [YES] key.

NOTE: The DTC is also shown in the (Each System Check) mode. This mode is called up on the Cruise Control Diagnosis screen by selecting the item (Cancel Code(s) Display).

8. Drive the vehicle at least 40 km/h (25 MPH) with cruise speed set.
9. If the cruise speed is canceled itself (without doing any cancel operations), a DTC will appear on select monitor display.

CAUTION:
- A DTC will also appear when cruise cancel is effected by driver. Do not confuse.
- Have a co-worker ride in the vehicle to assist in diagnosis during driving.

NOTE: DTC will be cleared by turning the ignition switch or cruise control main switch to OFF.