Disassembly and Reassembly

C: DISASSEMBLY





1. Remove connectors from plate
A) Shift-lock solenoid and "P" position switch connector
B) Indicator light connector





2. Remove indicator light.

NOTE: Be careful not to break the indicator light during removal.





3. Remove the clip.
4. Remove the button A.
5. Remove the two screws from the select lever grip.





6. While pressing the select lever button B, remove the select lever grip and indicator cover from the upper select lever, and then remove the select lever button and spring.

CAUTION: Position the select lever grip carefully so that the select lever button does not jump out.





7. Remove shift-lock solenoid and "P" position switch.
8. Remove lock plate.
9. Remove the cap, then the straight pin.





10. Remove the lower select lever, and then lift the upper select lever from the plate.

D: ASSEMBLY
1. Clean all parts before assembly.
2. Apply grease [NIGTIGHT LYW No. 2 or equivalent] to each part.
3. Assemble in the reverse order of disassembly.

NOTE:





^ When installing the lock plate, be careful to position it in the correct direction.





^ Be careful to install the spring and button into the select lever grip in the correct direction.

4. After completing the fitting, transfer the select lever to position "P"-"1", then check whether the indicator and select lever agree, whether the pointer and select lever agree, and what the operating force is.