RH Side

1. Release fuel pressure.

2. Open fuel flap lid, and remove fuel filler cap.

3. Disconnect battery ground cable.

4. Remove air intake duct and air cleaner assembly.

5. Remove resonator chamber.

6. Remove spark plug cords from spark plugs (#1 and #3 cylinders).
7. Remove power steering pump from bracket.

1. Remove V-belt covers.

2. Loosen lock bolt and slider bolt, and remove power steering pump drive V-belt.

3. Remove bolts which secure power steering pipes brackets to intake manifold.

4. Remove bolts which install power steering pump to bracket.

5. Place power steering pump on the right side wheel apron.

8. Disconnect connector from fuel injector.

9. Remove bolt which install injector pipe to intake manifold.

10. Remove bolt which installs injector pipe on intake manifold.
11. Remove fuel injector from intake manifold.

1. Remove fuel injector securing clip. (2500 cc models)

2. Remove fuel injector while lifting up fuel injector pipe.

12. Installation is in the reverse order of removal.

CAUTION: Replace O-rings and insulator with new ones.

Tightening torque:
3.4 ± 0.5 N.m (0.35 ± 0.05 kg.m 2.5 ± 0.4 ft.lb)

Tightening torque:
3.4 ± 0.5 N.m (0.35 ± 0.05 kg.m, 2.5 ± 0.4 ft.lb)