Installation

1. Insert frame rear end slit to two bolts filled temporarily to roof brace.




2. Align frame to reference pin installed on roof.




3. Tighten adjusting nut (that is, set frame at highest position).
Temporarily tighten bolts.
4. Install sunroof panel.

5. Adjust height by turning adjusting nut. Also adjust front, rear, right, and left side partitions.




Partition clearance:
5.9 ± 0.5 mm (0.232 ± 0.020 in)




Difference in height between roof panel and sunroof panel:
0 ± 1.0 mm (0 ± 0.039 in)




6. Tighten set bracket mounting bolts.




7. Tighten bolts.




8. Install drain tubes.

CAUTION: Insert drain tube securely into drain pipe.

Length: A
Approx. 20 mm (0.79 in)

9. Install roof trim.




10. Install garnish.

NOTE: Place garnish joint at rear center of body.

11. Install sunroof trim, pillar trim, rear quarter trim etc.
12. Check the following items after assembling all parts;
1. Garnish must be free from waves.
2. When sunroof is fully closed, must be no clearance between garnish and sunroof trim.
3. Sunroof must be free from slack and noise when it is fully opened and closed.