Carpet: Service and Repair
Floor MATSupplemental Restraint System "Airbag" Airbag system wiring harness is routed near floor mat.
CAUTION:
- All Airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuit.
- Be careful not to damage Airbag system wiring harness when servicing floor mat.
1. Remove these parts
a. front seats.
b. rear seat cushion.
c. center tray, indicator cover, cover assembly, and console box, depending on the specifications.
d. front pillar lower trim panel.
e. center pillar lower trim panel.
f. three clips under rear seat cushion.
g. rear cover side plate and rear pillar lower trim.
2. Pull out edge in the groove of side sill cover.
3. Remove these parts
a. four clips under front seat.
b. four clips in toe board area.
NOTE: When pulling out edge, do not pull mat alone; pull mat together with edge. Pry off two steel clips on side sill front cover and one on side sill rear cover using screwdriver.
c. mat hook.
d. mat from toe board area.
e. mat from heater unit.
4. Roll mat, and take it out of opened rear door.
Installation is in the reverse order of removal.
NOTE:
- Secure mat firmly with hook and velcro tape.
- Insert mat edge firmly into the groove of side sill cover.