Except California

1. Install intake manifold onto cylinder heads.

CAUTION: Always use new gaskets.

Tightening torque:
25 ± 2 Nm (2.5 ± 0.2 kg.m, 18.1 ± 1.4 ft.lb)




2. Connect fuel hoses.




3. Connect connector to oil pressure switch.




4. Connect connector to crankshaft position sensor.




5. Connect connector to camshaft position sensor.




6. Connect knock sensor connector.




7. Connect connectors to engine coolant temperature sensor.




8. Install air intake chamber stay RH and engine harness bracket, and connect engine harness connectors to bulkhead connectors.




9. Connect brake booster hose.




10. Connect engine coolant hose to throttle body.




11. Connect PCV hose (A) and vacuum hose (B) to intake manifold.




12. Connect spark plug cords to ignition coil and ignitor assembly.




13. Install fuel pipe protector.




14. Install power steering pump on bracket.
1. Install power steering pump on bracket, and tighten bolts.

Tightening torque:
20.1 ± 2.5 Nm (2.05 ± 0.25 kg.m, 14.8 ± 1.8 ft.lb)




2. Install power steering pipe brackets on the right side of intake manifold.




3. Install power steering pump drive V-belt.




4. Adjust V-belt.
5. Install V-belt covers.




15. Connect accelerator cable.




16. Install air cleaner element.
17. Install air cleaner upper cover, air intake duct and air intake chamber as a unit.




CAUTION: Before installing air cleaner upper cover, align holes with protruding portions of air cleaner lower case, then secure upper cover to lower case.




18. Tighten bolts which install air intake chamber to stays.

Tightening torque:
4.9 ± 0.5 Nm (0.5 ± 0.05 kg.m, 3.6 ± 0.4 ft.lb)




19. Connect connector to mass air flow sensor.




20. Connect connector to fuel pump relay.




21. Install fuel tiller cap.




22. Connect battery ground cable.