Except California

1. Assemble fuel pipes, etc. to intake manifold.




2. Install fuel injector pipe.




3. Tighten two bolts which install fuel pipes on intake manifold.




4. Tighten two bolts which install fuel pipes on the left side of intake manifold.




5. Connect left side fuel hose to injector pipe, and tighten clamp screw.




6. Install fuel injectors.

CAUTION: Always use new O-rings and insulators.




7. Tighten bolts which install injector pipe on intake manifold.

Tightening torque:
3.4 ± 0.5 Nm (0.35 ± 0.05 kg.m, 2.5 ± 0.4 ft.lb)




8. Install purge control solenoid valve.




9. Install engine harness onto intake manifold.
10. Connect connectors to fuel injectors and purge control solenoid valve.
11. Hold engine harness by harness bands.




12. Assemble throttle body to intake manifold.

CAUTION: Replace gasket with a new one.

Tightening torque:
22 ± 2 Nm (2.2 ± 0.2 kg.m, 15.9 ± 1.4 ft.lb)




13. Connect connectors to throttle position sensor (A) and idle air control solenoid valve (B).




14. Install ignition coil and ignitor assembly.
15. Connect connector to ignition coil and ignitor assembly.




16. Install engine ground terminal to intake manifold.

Tightening torque:
18.6 ± 1.5 Nm (1.9 ± 0.15 kg.m, 13.7 ± 1.1 ft.lb)