Fuel Filler Hose: Service and Repair
FUEL FILLER PIPEA: REMOVAL
1) Release fuel pressure.
2) Disconnect battery ground cable.
3) Drain fuel from fuel tank.
4) Remove right rear wheel.
5) Open fuel filler flap and remove filler cap.
6) Remove screws holding packing in place.
7) Lift-up the vehicle.
8) Remove fuel tiller pipe protector.
9) Loosen clamp, and separate air vent hose (B) and fuel filler hose (A) from air vent and fuel filler pipe.
10) Remove fuel filler pipe to under side of the vehicle.
B: INSTALLATION
1) Hold fuel filler flap open.
2) Set fuel saucer (A) with rubber packing (C), and insert fuel filler pipe into hole from the inner side of apron.
3) Align holes in fuel filler pipe neck and set cup (B), and tighten screws.
NOTE: If edges of rubber packing are folded toward the inside, straighten it with a screwdriver.
4) Insert fuel filler hose (A) approximately 25 to 30 mm (0.98 to 1.18 in) over the lower end of fuel filler pipe and tighten clamp.
CAUTION: Do not allow clips to touch air vent hose (B) and rear suspension crossmember.
5) Insert air vent hose approximately 25 to 30 mm (0.98 to 1.18 in) into the lower end of air vent pipe and hold clip.
L=25-3Omm (098- 1.18 in)
6) Install fuel filler pipe protector.
7) Install right rear wheel.
8) Connect connector to fuel pump relay.
9) Connect battery ground cable.