Transmission Case

2. TRANSMISSION CASE





1) Drive out spring pin (1) with ST, and remove 5th shifter fork (2). ST 398791700 STRAIGHT PIN REMOVER
2) Remove plugs (3), springs (4) and checking balls (5).





3) Drive out spring pin (6), and pull out 3-4 fork rod (7) and shifter fork (8).

NOTE: When removing rod, keep other rods in neutral. Also, when pulling out straight pin, remove it toward inside of case so that it may not hit against case.

4) Drive out straight pin (9), and pull out 1-2 fork rod (10) and shifter fork (11).





5) Pull out straight pin (12), and remove idler gear shaft (13), reverse idler gear (14) and washer (15).
6) Remove outer snap ring (16) , and pull out reverse shifter rod arm (17) from reverse fork rod (18) . Then take out ball, spring and interlock plunger from rod. And then remove rod.

NOTE: When pulling out reverse shifter rod arm, be careful not to let ball pop out of arm.

7) Remove reverse shifter lever (19).





8) Remove differential side retainers using ST. ST 499787000 WRENCH ASSY





9) Remove outer snap ring (20) and pull out speedometer driven gear (21). Next, remove vehicle speed sensor 2, oil seal, speedometer shaft (22) and washer.