Fuel Filter: Testing and Inspection
REMOVALFig. 21:
1. Remove 3 flange bolts and remove filter/pump bracket. See Fig. 21.
2. Disconnect fuel pump electrical connector.
Fig. 22:
3. Disconnect hoses from fittings A and B. Cap off hoses to prevent fuel spillage. See Fig. 22.
Fig. 24:
4. Disconnect hose at D. See Fig. 24.
5. Remove filter.
INSPECTION
1. Inspect filter for dirt or water sediment.
2. If filter is clogged or cracked, or if replacement interval has been reached, replace filter.
3. If water is found in filter, shake filter with inlet facing down to expel water (inspection of the fuel tank is advised).
INSTALLATION
1. Insert filter into hose at D. See Fig. 24.
Fig. 25:
2. Turn ears of clip as shown. See Fig. 25.
3. Connect hoses at A and B. See Fig. 22.
Fig. 28:
4. Connect fuel pump electrical connector. Do not allow harness to sag under vehicle. See Fig. 28.
Fig. 29:
5. Fasten filter/pump bracket to body and torque fasteners to 5.3 - 5.6 ft lb (7.2 - 7.6 Nm).
Fig. 30:
Fig. 31:
6. Using Fig. 30 and Fig. 31, confirm hoses are connected and routed correctly.