Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION; 2013 MY FR-S [03/2012 -]
1. INSTALL STEERING SENSOR
(a) Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.
NOTICE:
Do not rotate the spiral cable until the steering sensor has been attached to it.
2. ALIGN FRONT WHEELS TO FACEING STRAIGHT AHEAD
3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
NOTICE:
* Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch on (IG).
* Do not rotate the spiral cable sub-assembly without the steering wheel with the battery connected and the ignition switch on (IG).
* Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least for 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the front wheels are facing straight ahead.
(d) Set the turn signal switch to the neutral position.
NOTICE:
If it is not in the neutral position, the turn signal switch pin may snap.
(e) Engage the 3 claws to install the spiral cable with sensor sub-assembly.
(f) Connect the each connector.
4. INSTALL UPPER STEERING COLUMN COVER Installation
5. INSTALL LOWER STEERING COLUMN COVER Installation
6. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Installation
7. INSTALL NO.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
8. INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT Installation
9. INSTALL METER HOOD SUB-ASSEMBLY Installation
10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
11. INSTALL INSTRUMENT SIDE PANEL LH Installation
12. INSTALL STEERING WHEEL ASSEMBLY
Installation
13. INSPECT SRS WARNING LIGHT
Diagnosis System
14. VSC SENSOR NEUTRAL MEMORIZATION
Programming and Relearning