Oil Seal
Oil SealINSPECTION
Check the oil seal portion for leakage. If leakage is found, replace the oil seal with a new one.
REPLACEMENT
1. Clean the transmission exterior.
2. Remove the drain plug using TORX BIT T70, and drain the transmission gear oil completely.
NOTE:
Tighten the drain plug after draining gear oil.
3. Remove the rear exhaust pipe and muffler.
^ Non-turbo model
^ Turbo model
4. Remove the propeller shaft.
5. Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
6. Using the ST, install the oil seal.
ST 498057300 INSTALLER
7. Install the propeller shaft.
8. Install the rear exhaust pipe and muffler.
^ Non-turbo model
^ Turbo model
9. Pour gear oil and check the oil level.