Differential Side Retainer Oil Seal
Differential Side Retainer Oil SealINSPECTION
Check leakage of gear oil from the differential side retainer oil seal part. If there is oil leakage, replace with a new oil seal, and check drive shaft.
REPLACEMENT
1. Lift-up the vehicle.
2. Remove the drain plug using TORX BIT T70, and drain the differential gear oil completely.
3. Replace with a new gasket and tighten the drain plug using TORX BIT T70.
4. Remove the front and center exhaust pipe. (Non-turbo model)
5. Separate the front drive shaft from transmission.
6. Remove the differential side retainer oil seal.
NOTE:
^ Be sure to replace the differential side retainer oil seal after the procedure of removing the front drive shaft from transmission.
^ When removing the oil seal, using the ST 398527700 PULLER ASSY. Also when using a flat tip screwdriver, be careful not to scratch the differential side retainer
7. Using the ST, install the differential side retainer by slightly tapping with a plastic hammer.
ST 18675AA000 DIFFERENTIAL SIDE OIL SEAL INSTALLER
NOTE:
Apply oil to the oil seal lips.
8. Install the front drive shaft.
ST 28399SA010 OIL SEAL PROTECTOR
9. Install the front and center exhaust pipe. (Non-turbo model)
10. Lower the vehicle.
11. Pour gear oil through the gauge hole.