Transmission Speed Sensor: Service and Repair
Switches and HarnessREMOVAL
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1. Disconnect the ground cable from battery.
2. Remove the air intake duct and cleaner case. (Non-turbo model)
3. Remove the intercooler. (Turbo model)
4. Disconnect the connector of back-up light switch and neutral position switch.
^ Non-turbo model
Non-turbo model:
^ Turbo model
Turbo model:
5. Lift-up the vehicle.
6. Remove the back-up light switch and neutral position switch with harness.
INSTALLATION
1. BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH
1. Install the back-up light switch and neutral position switch with harness.
Tightening torque:
32.3 Nm (3.3 kgf-m, 23.8 ft. lbs.)
2. Connect the connector of back-up light switch and neutral position switch.
3. Install the air intake duct and cleaner case. (Non-turbo model) 4. Install the intercooler. (Turbo model)
5. Connect the battery ground cable to battery.
Neutral Switch & Backup Switch Testing
Switches and Harness
INSPECTION
BACK-UP LIGHT SWITCH
Inspect the back-up light switch.
NEUTRAL POSITION SWITCH
1. Turn the ignition switch to OFF.
2. Disconnect the connector of neutral position switch.
3. Measure the resistance between neutral position switch terminals.
Non-turbo model:
Non-turbo model:
Turbo model:
Turbo model:
^ Non-turbo model
Non-turbo model:
^ Turbo model
Turbo model:
4. Replace defective parts.