Camshaft Position Sensor: Service and Repair
Camshaft Position SensorREMOVAL
1. Disconnect the ground cable from battery.
2. Disconnect the connector from the camshaft position sensor RH.
3. Remove the camshaft position sensor RH from the rear side of cylinder head.
4. Remove the camshaft position sensor LH in the same procedure as RH side.
INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Camshaft position sensor support: 6.4 Nm (0.65 kgf-m, 4.7 ft. lbs.)
Camshaft position sensor: 6.4 Nm (0.65 kgf-m, 4.7 ft. lbs.)