Ignition Coil Pack: Service and Repair

To Remove
1. Unplug the ignition discharge module's 10-pin connector.
2. Remove the 4 bolts.
3. Lift up the ignition discharge module.
4. Turn the ignition discharge module upside down and remove the 8 screws.
5. Lift off the black bottom part of the ignition discharge module.
6. To change the spring, use a screwdriver to prise out the old spring.

To Fit
1. Fit a new spring in place.
2. Fit in reverse order.
Tightening torque, ignition discharge module bolts (4): 11 Nm (8 ft lbs)