Electronic Control Module

Electronic control module, SE/US/CA
1 Disconnect the negative lead (.) from the car battery.

2 Cars without passenger airbag
Remove the glove compartment and air distribution damper.
Cars with passenger airbag
Remove the complete airbag. including bracket and air distribution damper.
3 Lift down the electronic control module. 4 Plug in the 25 pin connector to the electronic control module.
5 Install the pop rivets.
6 Screw down the electronic control module using the two screws.
Proceed to point 9 in "Jumper Plug".







Electronic control module, EU
1 Disconnect the negative lead (-) from the car battery.

2 Cars without passenger airbag
Remove the glove compartment and air distribution damper.
Cars with passenger airbag
Remove the complete airbag, including bracket and
air distribution damper.
3 Insert the plate (under section of casing) between the electronic control module and the bracket.
4 Plug in the 25 pin connector to the electronic control module
5 Install the lid (hook on, upper section of casing) on the electronic control module.
6 Screw together lid and plate with the two screws.
7 Install the pop rivets.
8 Screw down the electronic control module using the two screws.