3 Circuit Breaking

There is a 3 circuit breaking function incorporated in the alarm control module which takes over control of the functions listed below when the alarm is armed. This prevents the engine from being started when the alarm is set off as follows:

- Starter relay (ignition "ST" +50) does not receive operating voltage as the alarm control module (pin 8) breaks the voltage if a attempt is made to start the car.
- The fuel pump relay receives no operating voltage as the alarm control module (pin 9) breaks the voltage. The car receives no fuel - the car cannot be push started either
- Engine control system does not receive +15 as the alarm control module (pin 22) breaks the voltage.

Connection
3 circuit breaking is connected when the rest of the alarm is armed.

Disconnection
3 Circuit breaking is disconnected when the rest of the alarm is disarmed.

Self-arming, 3 circuit breaking
3 circuit breaking can be programmed independently for self-arming, or automatic arming without the use of the remote control or the car key.

Self-arming, theft alarm
The entire theft alarm can also be programmed for self-arming. In this case, 3 circuit breaking is automatically included when the alarm is armed. Also see the section on "Programming" for further information.