Installing
Installation
1 Install a new seal between the heater housing and bulkhead.
2 Install the heat exchanger in housing. Install housing in position. Make sure that the lower edge of the housing is in its groove.
3 Install screws to housing.
4 Install cable entry in position.
5 Install floor vents.
6 Plug in connectors for servomotor, fan motor and blended air sensor (cars with Automatic Climate Control (ACC) only).
7 Install the plastic holder securing the wiring harness under the heater housing.
8 Install the air duct which goes to the rear floor.
9 Install the defroster vent and defroster air ducts.
10 Suspend the electrical distribution box in position and install the wiring harness cable tie to the heater housing.
11 Place the combined instrument on the steering column bracket.
12 Place the facia in position and do up screws.
Make sure that the facia is guided into the groove on the guide lug.
13 Screw the combined instrument into position.
14 Connect cables to loudspeakers.
15 Install air ducts to left-hand and right-hand facia vents.
16 Using a cable tie, secure the wiring harness to the left-hand air duct. (Right-hand drive cars right-hand air duct).
17 Install the screws securing the left-hand and right-hand side defroster ducts.
18 Install the instrument panel facia vent to its hose.
19 Plug in electrical connectors to instrument panel.
20 Install the center facia vent and hose.
21 Install the instrument panel to facia.
22 Plug in connectors and install selector switch.
23 From year model M1988
Install left-hand and right-hand floor duct.
24 Install heater control panel or ACC control module.
25 Install cover on steering column joint.
26 Install steering wheel.
27 Lift and install electrical distribution box.
28 Install facia vents and glove compartment.
29 Install the top of the facia, loudspeaker grilles and A pillar trim.
30 Install ashtray holder and ashtray.
31 Install the panel sections to the center console and the acoustic insulation panels under the facia.
32 Install fan housing.