To Change the Selector Rod

1. Follow the description for removing the gear lever housing up to the point at which the housing can be removed.





2. Lift the car and release the clamp on the selector rod.





3. Lower the car and withdraw the selector rod into the car. Check and, if necessary, change the rubber gaiter.





4. Fit a new selector rod and adjust the gear positions. Refer to "To Preset and Adjust the Gear Positions" at Shift Linkage, M/T/Service and Repair. Service and Repair

If the universal joint needs changing, follow the description for changing the selector rod up to the point where the selector rod is withdrawn into the car.
The universal joint can then be changed. The gear positions must be adjusted as described. Refer to "To Preset and Adjust the Gear Positions" at Shift Linkage, M/T/Service and Repair. Service and Repair