Convertible Roof Seals - Microfiche Correction

91saab03

CATEGORY
Microfiche Discrepancy

SECTION PAGE
14 18
ISSUE CODE
5/91-0117 844


Subject: Convertible Roof Seals

Application: 900 US Edition 6, Grid 2-K04








The listing on this page for the roof seals and related holders indicates that these components are included in a complete roof assembly. This is not the case. If required these seals must be purchased independent of the roof assembly. See below for a correct listing of positions 1 through 5A.


Pos Part Number Notes Qty. Description S/L

1 69 50 216 LH ....................... 1 Seal

1 69 50 208 RH ...................... 1 Seal

2 69 51 396 LH ....................... 1 Seal

2 69 51 388 RH ...................... 1 Seal

3 69 51 370 40) See MS 462 ............ 1 Seal

3 69 53 939 41) ...................... 1 Seal

4 69 51 362 LH ....................... 1 Bracket

4 69 51 354 RH ...................... 1 Bracket

5 69 51 347 LH, (41 53 037) ............ 1 Bracket

5 69 51 339 RH, (41 53 029) ............ 1 Bracket

5A 69 99 999 167) ..................... 2 Clip


40) VIN -L7000109
41) VIN L700110-
167) VIN L7014501-





1) Carefully align the appropriate microfiche card on the matrix.


2) The black square will appear directly on the grid(s) to be marked.


3) Using a red "El Marko" permanent pen (or similar type) mark the fiche square(s).


Note:

If you use a fine tipped pen you can write the position number where the error is. This will save looking up microfiche discrepancies unnecessarily.

Unless fiche are correctly marked, the microfiche discrepancy system will be of little help in your parts department. Use the system and avoid costly ordering errors.