Shifter M/T: Service and Repair
To RemoveWith The Gear Lever Housing Removed
The gear lever can also be removed by folding up the gaiter and removing the three screws retaining the gear lever.
1. Remove the gear lever from the gear lever housing.
2. Remove the tubular dowel and remove the sleeve, spring and bearing components.
3. Unscrew the latch stud from the latch rod.
4. Remove the gaiter from the sleeve.
5. Remove the knob from the lever.
6. Remove the sleeve and the latch rod. Assemble in the reverse order.
Ensure that the ground side of the rod is in such a position that the hole is open when the wire clip is fitted.
NOTE: Before fitting the wire clip dowel, adjust the projecting length of the latch stud to 22 +/- 0.51-0 mm (0.89 +/- 0.02/-0 in)
1. Knob
2. Gear lever
3. Sleeve
4. Latch rod
5. Rubber gaiter
6. Cover
7. Bearing
8. Spring
9. Wire clip
10. Spring
11. Latch stud
12. Carrier
13. Bearing